PLUGIN catalogue 2018

ERVAC DVI-I - Technical data 44 Gasket : Viton Technical Data Electrical performance ITEM TEST CONDITION REQUIREMENT Contact resistance Bulk resistance measured between plug solder tails and receptacle solder tails per ANSI/EIA-364-23 20 mΩmaximum, initial per contact mated pair - 10 mΩmaximum change from initial reading per contact mated pair Shell resistance Bulk resistance measured between ground leg on receptacle shield and the plug cable braid. Test current = 100mA - Test voltage = 5 Volts DC open circuit maximumper ANSI/EIA-364-06A-83 50 mΩmaximum, initial - 50 mΩ maximum change from initial reading Insulation resistance Test voltage = 500 Volts DC +/- 50V unmated and unmounted per ANSI/EIA 364-21 method C 1 GΩminimumbetween adjacent contacts and contact and shell Dielectric withstanding voltage Test voltage = 500 Volts DC +/- 50V unmated and unmounted per ANSI/EIA 364-20 method C at barometric pressure of 15 psi No ashovern no sparkover, no excess leakage, no breakdown Contact current rating Maximum ambient = 55°C - Maximum temperature change = 85°C per ANSI/EIA- 364-70, TP-70 3.0 A maximum Applied voltage rating 40 Volts AC (rms) continuous maximum on any signal pin with respect to the shield Electrostatic discharge Test unmated from1 kV to 8 kV in 1 kV steps using 8 mmball prob per IEC 801-5 - Contact discharge to shell - Air discharge perpendiculare to shell - Air discharge at angle to shell No evidence of discharge to contacts at 8kV. Discharge to the shell is acceptable. Signals Time Domain Impedance (T.M.D.S.) Risetime = 330 pS (10%-90%) - S:G ratio per DVI pin designation - Di erential measurement specimen environment imperdance = 100 Ω - Di erential source- side receptacle connector mounted on a controlled impedance P.C.B. xture per ANSI/EIA-364-108 draft proposal 100 Ω +/- 15% DVI connector variations are available : DVI-I (Dual link) - DVI-I (Integrated), it combines both digital and analog in the same connector DVI-I (Single link) DVI-A - DVI-A (Analog), it supports analog only. DVI-D (Dual link) - DVI-D (Digital), it supports digital signals only DVI-D (Single link)